Changeset 961

Timestamp:

06/22/09 23:18:59 (3 years ago)

Author:

jdunn

Message:

Trying to rollback just enough of the repeater code to make IR work again.

File:

• trunk/firmware/usb_ir_body/usb_ir_body/ir.asm (modified) (3 diffs)

trunk/firmware/usb_ir_body/usb_ir_body/ir.asm

@@ -26 +26 @@
 export twrap_int
 export write_signal
-export send_loop
+;export send_loop
 export ir_repeater
 
 ; exported variables
 export rx_flags
-export tx_pins
-export tx_state
+;export tx_pins
+;export tx_state
 
 AREA bss
@@ -265 +265 @@
 
 ; in repeater mode fiddle with the LED by changing tx_state
-
-or REG[TX_BANK], TX_MASK
+;or REG[TX_BANK], TX_MASK
   ; if here, it's a falling edge
   tcapi_fall:
     mov [rx_pulse], 0x80 ; set pulse bit to indicate space
-mov [tx_state], TX_MASK
+;mov [tx_state], TX_MASK
     jmp tcapi_done
 
@@ -276 +275 @@
   tcapi_rise:
     mov [rx_pulse], 0x00 ; clear pulse bit to indicate pulse
-mov [tx_state], 0
+;mov [tx_state], 0
     jmp tcapi_done
 
   tcapi_done:
-;    jmp load_value          ; store into data buffer
+    jmp load_value          ; store into data buffer
   tcapi_load_done:
     mov REG[FRTMRL], 0      ; reset timer low byte