Cannot send with transmitter 3

[floyduww]

Sending on transmitter 3 does not work. using:

irsend set_transmitters 1 
irsent send_once DCt2000 3    --- works
irsend set_transmitters 2 
irsent send_once DCt2000 3    --- works
irsend set_transmitters 3 
irsent send_once DCt2000 3    --- DOES NOT WORK
irsend set_transmitters 4 
irsent send_once DCt2000 3    --- works

any other combination of transmitters will submit on all specified transmitters but 3.

Joseph I have also talked to you via email about this. Just thought this way other uses may see the issue too.

Thanks Chris

[jdunn]

I think I misunderstood when we spoke about it in email then. If the problem is just that channel 3 never sends then that is most likely a hardware problem that can only be resolved with an exchange. Can you explain how you are checking that each transmitter works? If there is no flicker visible through a camera viewfinder for ONLY a single channel, even when transmitting on ALL channels then we just need to do an exchange. Sorry for the inconvenience.

[floyduww]

To test I had all 4 transmitters hooked up. And I held each one up to the cable box one at a time to test. And I ran the tests multiple times. I also moved the transmitters 1 port over to make sure I didn't have a bad transmitter and had the same results.

[jdunn]

Did you email me directly about an exchange? If so I should have closed this ticket then.....

[floyduww]

I did email directly about this. And the replacement works well on all 4 channels. Thank you.