Show page Old revisions Backlinks This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong. Below is the igclient usage statement. To make the documentation more manageable, the argument documentation is broken into several categories: * [[:igclient:Receiving]] * [[:igclient:Sending]] * [[:igclient:GPIO|igclient:GPIO Functionality]] * [[:igclient:Miscellaneous]] <code> Usage: igclient [[:OPTION...]] -d, --device=number Specify the device to connect with (by index or id). --interactive Use the client interactively. -l, --log-file=filename Specify a log file (defaults to "-"). -q, --quiet Reduce the verbosity. -v, --verbose Increase the verbosity. --get-version Return the version of the device firmware. --get-features Return the features associated w/ this device. --send=filename Send the pulses and spaces from a file. --receiver-on Enable the receiver on the usb device. --receiver-off Disable the receiver on the usb device. --get-pins Get the pin values. --set-pins=values Set the pin values. --get-buffer-size Find out the size of the RAM buffer used for sends and receives. --write-block=filename Write the block specified in the file. --execute Execute code starting at address 0x1fc0 on the device. --lcd-text=string Send a bulk transfer of pin settings to write the argument to an LCD. --reset Reset the USB device. --get-channels Check which channels are used during transmits. --set-channels=channels Set which channels are used during transmits. --get-carrier Check the carrier frequency for transmits. --set-carrier=carrier (Hz) Set the carrier frequency for transmits. --get-pin-config Retrieve the internal pin state. --set-pin-config Store the internal pin state. --get-output-pins Check which pins are set to be outputs. --set-output-pins=pins Set which pins should be outputs. --get-pullup-pins Check which pins are set to be pullups. --set-pullup-pins=pins Set which pins should be pullups. --get-open-drain-pins Check which pins are set to be open drains. --set-open-drain-pins=pins Set which pins should be open drains. --get-high-sink-pins Check which pins are set to be high sinks. --set-high-sink-pins=pins Set which pins should be high sinks. --get-threshold-pins Check which pins are set to be thresholds. --set-threshold-pins=pins Set which pins should be thresholds. --sleep=seconds Sleep for X seconds. --get-id Fetch the unique id from the USB device. --set-id=STRING Set the unique id from the USB device. Help options: -?, --help Show this help message --usage Display brief usage message </code>